codes.iccsafe.org

Distinguish fireblocking from draftstopping requirements when using gypsum board per IBC Chapter 7

Determine when duct leakage (duct blaster) testing is required and its thresholds under the locally adopted IECC

Confirm a pole or ground sign design meets IBC Appendix H submittal requirements

Determine when a retaining wall triggers a building permit and engineered design under the International Residential Code (IRC)

Assemble the sealed engineering package a pole sign permit submittal requires

Complete and post the required insulation certificate at final inspection under the locally adopted IRC energy code

Select an approved backer board (not greenboard) for tile in tub/shower surrounds per IBC

Confirm code-required blower door air leakage (ACH50) testing thresholds under the locally adopted IECC

Look up prescriptive insulation R-value and fenestration U-factor requirements by climate zone in the locally adopted IECC

Determine required attic net free ventilation area under IRC R806.2 and its 1:150/1:300 exception

Determine when a pole sign footing needs a stamped engineering design

Verify ASTM E84 flame spread classification requirements for interior wood millwork paneling under IBC Chapter 8

Determine required interior vapor retarder class by climate zone under IRC R702.7

Install WRB/housewrap per IRC R703.2 and manufacturer instructions

Confirm nail penetration/embedment requirements into studs vs. sheathing by siding type

Apply kick-out flashing at roof-wall intersections

Decode IBC 716 fire-rated glazing marking/label requirements on a curtain wall submittal review

Decide between roof re-cover and full tear-off under IBC/IEBC reroofing provisions

Determine IBC roof drainage and ponding-water code requirements for a low-slope roof

Determine when high-piled combustible storage permits are required under IFC Chapter 32, including the height trigger.

Explain the code distinction between a mezzanine and a rack-supported (or free-standing) platform, and why it matters for permitting.

Determine when a warehouse rack installation triggers a building permit and/or structural special inspection under the IBC/ASCE 7 nonbuilding-structure provisions.

Confirm footing/foundation inspection requirements for a freestanding sign structure before backfilling

Confirm code treatment of awning/canopy-mounted signage

Apply IBC Appendix H sign provisions correctly, accounting for its non-mandatory adoption status

Determine the model-code permit exemption height threshold for fences under IBC/IRC Section 105.2, and whether it still applies to pool-barrier fences.

Determine whether a pane of glass in a house (e.g., a fixed panel next to a swinging entry door) is a 'hazardous location' requiring safety glazing under the residential code.

Determine whether a large storefront or office window assembly triggers the IBC's commercial 'glazing in windows' hazardous-location safety-glazing requirement.

Determine whether glazing in and adjacent to a commercial entrance door requires safety glazing under the IBC, and confirm the identification mark it must bear.

Look up the maximum U-factor and SHGC a commercial curtain wall or storefront glazing system must meet under the IECC for a specific climate zone.

Determine whether a masonry chimney requires seismic reinforcement and anchorage under IRC Section R1003, based on the project's Seismic Design Category.

Identify what changed for chimneys/fireplaces between the 2021 and 2024 IRC editions to flag for a jurisdiction upgrading its adopted code.

Confirm the IRC R1001 hearth-extension and clearance-to-combustibles dimensions for a masonry fireplace before framing sign-off.

Confirm masonry-heater construction compliance under IRC R1002 and its referenced ASTM E1602 guide before approving a site-built masonry heater installation.

Determine whether International Building Code Appendix H (Signs) applies to a jurisdiction's sign design/construction requirements

Determine the minimum required fire flow for a project per IFC Appendix B without illegally reproducing the copyrighted code text

Determine residential pool-barrier/fence requirements under the International Swimming Pool and Spa Code (ISPSC) Chapter 3