Confirm OSHA touchpoints for crane and bucket-truck (aerial lift) use during sign installation

Steps

1. Determine whether the equipment is a vehicle-mounted aerial lift (regulated under 29 CFR 1926.453) or meets the scope of the cranes-and-derricks standard (1926 Subpart CC/1926.1400 series) — most bucket trucks used for sign install fall under the aerial-lift standard rather than the crane standard
2. Confirm operator training and pre-use inspection requirements under 1926.453 (lift controls, outriggers, body belt/lanyard or harness anchorage, and load limits) before elevating personnel to install or service a sign
3. If overhead power lines are present, maintain minimum clearance distances per the applicable power-line-safety provisions, treating lines as energized unless the utility confirms de-energization and visible grounding at the worksite — do not assume a fixed clearance number without checking the voltage-based table for the line involved
4. If a crane (rather than an aerial lift) is used to set a monument or pylon sign structure, confirm the operator is certified/qualified and that a lift plan addresses ground bearing capacity, swing radius, and rigging for the sign's specific weight and dimensions
5. Coordinate with the utility or a qualified person before working near power lines rather than relying solely on the crew's own distance estimate