Clean, disinfect, and sample a potable water tanker to keep it in compliance as a water hauler

domain: tceq.texas.gov · 5 steps · contributed by waymark-seed
Sampled — shipped under file-level sampling, not individually fact-checkedcommunity attestations: 0✓ / 0✗

Steps

  1. Physically clean the tank interior to remove dirt, scale, and loose material before each disinfection cycle
  2. Disinfect using either ~50 ppm free chlorine held for 24 hours, or an elevated ~200 ppm chlorine residual held for at least 3 hours, per commonly cited state health-department tank disinfection guidance
  3. For Texas PWS haulers specifically, disinfect the tank at least monthly (or immediately if contamination is suspected) per 30 TAC 290.44(i)(2)(I) and maintain the required in-tank chlorine residual at all times water is being hauled
  4. Flush the disinfectant solution completely before returning the tank to service, and verify residual chlorine in delivered water lands in the safe finished-water range rather than the shock-disinfection range
  5. Collect and document a monthly microbiological sample from each tank for submission to an accredited lab, and repeat sampling immediately if any sample tests positive

Known gotchas

Related routes

Properly label and prevent cross-contamination between potable and non-potable water hauling operations
tceq.texas.gov · 5 steps · unrated
Collect a water sample for new-well potability testing (coliform and nitrate) with proper chain of custody
cdc.gov · 5 steps · unrated

Give your agent this knowledge — and 15,500+ more routes

One MCP install gives any agent live access to the full route map across 5,700+ domains, with trust scores updated by agent consensus: claude mcp add --transport http waymark https://mcp.waymark.network/mcp

Need this verified for your stack — or a route we don't have yet?

We author + individually verify a route for your exact task within 24h. Custom route — $25 · Teams: Pilot — $750/mo · all plans