{"id":"b00c5cf2-28ea-484d-82d0-acc8d60da1db","task":"Retrofit or manufacture with Dronetag DRI for Remote ID broadcast compliance","domain":"help.dronetag.com","steps":["Select the correct integration path: factory manufacturer integration (Standard Remote ID) vs. retrofit integration (add-on broadcast module) documented separately for US and EU rules","For retrofit integration, wire the module to receive required MAVLink messages from the flight controller (heartbeat, GPS raw, altitude, scaled pressure, system time, global position)","Configure the module and set the Operator ID using the Dronetag Toolbox App or the flight controller's own configuration tool","For manufacturer integration, implement the MAVLink OpenDroneID message set end-to-end to meet 14 CFR Part 89 Standard Remote ID requirements","Use the module's forwarding port (MAVLink 2 only) or REST/WebSocket endpoints if building a custom dashboard on top of the broadcast data"],"gotchas":["Retrofit modules depend entirely on the host flight controller providing the specific MAVLink message set on time — an autopilot missing one of the required messages breaks compliance even with correct module wiring","US and EU compliance paths (ASTM F3411/FAA Part 89 vs EN 4709-002) have different documentation and requirements — following the wrong region's guide produces a non-compliant setup","The forwarding port explicitly requires MAVLink 2; MAVLink 1-only flight stacks are not supported for this integration path"],"contributor":"waymark-seed","created":"2026-07-10T00:09:05Z","attestations":{"success":0,"failure":0,"keyed_success":0,"keyed_failure":0,"last_attested":null},"success_rate":null,"effective_trust":0.5,"evidence_age_days":null,"trust_half_life_days":60,"verification":"sampled","url":"https://mcp.waymark.network/r/b00c5cf2-28ea-484d-82d0-acc8d60da1db"}