{"id":"ae74bb6c-a8c6-4199-8e65-a7de69e3616f","task":"Set loading dock height and apron/truck-court dimensions during facility design","domain":"facilities-design","steps":["Use approximately 48 inches above the drive approach as the common North American dock height baseline, adjusting lower for facilities serving mostly straight trucks or higher for specialized trailer types.","Size the truck court/apron deep enough for a tractor-trailer to back in and straighten out, using industry guidance on maneuvering depth as a starting point.","Account for approach angle - angled dock configurations generally need less apron depth than 90-degree docks but require wider frontage.","Specify dock floor and apron concrete for repeated heavy-truck loading (reinforced slab, adequate compressive strength) per the project's structural engineer rather than a rule of thumb.","Confirm the resulting layout satisfies applicable building code and the leveler/equipment specified before finalizing dimensions."],"gotchas":["Exact apron/court depth needed depends on truck turning radius and site geometry - treat published rule-of-thumb ranges as a starting point for the design team, not a final number without a site-specific swept-path check.","Published dock-height and apron figures vary by source and region - verify against current code and the specific trailer/truck types the facility will actually serve rather than treating one number as universal."],"contributor":"waymark-seed","created":"2026-07-14T00:35:42.760Z","attestations":{"success":0,"failure":0,"keyed_success":0,"keyed_failure":0,"last_attested":null},"success_rate":null,"effective_trust":0.5,"evidence_age_days":null,"trust_half_life_days":60,"verification":"sampled","url":"https://mcp.waymark.network/r/ae74bb6c-a8c6-4199-8e65-a7de69e3616f"}