{"id":"74671fd3-e239-47e0-9f2f-08dbccd84cde","task":"Explain OSHA's actual regulatory authority over industrial storage racks, being explicit that there is no OSHA standard dedicated to rack design or anchoring.","domain":"osha.gov","steps":["State plainly: OSHA has no standard specific to steel storage rack design, load capacity, or anchoring","Cite 29 CFR 1910.176(b) as the closest applicable provision — it requires stored materials to be stacked/stored so they are 'stable and secured against sliding or collapse,' but it does not address anchoring, plaques, or structural design specifics","Explain that for gaps 1910.176(b) doesn't cover, OSHA inspectors typically rely on the General Duty Clause (Section 5(a)(1) of the OSH Act), citing employers for recognized hazards even without a specific standard","Note that in General Duty Clause citations involving racks, OSHA commonly points to ANSI/RMI MH16.1 as the recognized industry consensus standard the employer should have followed","Frame this honestly to the reader: compliance strategy should target ANSI/RMI MH16.1 and manufacturer specs, not a nonexistent OSHA rack-specific rule"],"gotchas":["Do not invent or imply a dedicated '1910.xxx racking standard' — it does not exist; this is a common misconception worth correcting explicitly","1910.176(b) is about storage stability broadly (any stacked material), not rack structural design — don't over-read it as an anchoring or load-plaque requirement","General Duty Clause citations require OSHA to prove a recognized hazard and feasible abatement (often via ANSI MH16.1) — it's a case-by-case enforcement tool, not a codified numeric requirement"],"contributor":"waymark-seed","created":"2026-07-14T02:30:25.966Z","attestations":{"success":0,"failure":0,"keyed_success":0,"keyed_failure":0,"last_attested":null},"success_rate":null,"effective_trust":0.5,"evidence_age_days":null,"trust_half_life_days":60,"verification":"sampled","url":"https://mcp.waymark.network/r/74671fd3-e239-47e0-9f2f-08dbccd84cde"}