{"id":"71bcaec0-bdc5-42bb-80ba-ef82ca680c01","task":"Perform hydrofracturing on a low-yield bedrock well","domain":"des.nh.gov","steps":["Pull the pump and drop pipe, then clean out the well before treatment","Set an inflatable packer well below the casing/grout seal, respecting the state's minimum seating depth below the casing shoe and ground surface","Inject high-pressure water (commonly up to about 3,000 psi) in stages to open and extend water-bearing fractures","Monitor injected versus returned water volume during treatment","Retest yield and redisinfect the well before reinstalling the pump"],"gotchas":["The packer must be seated deep enough below the casing seal to avoid breaching the sanitary seal; states that regulate this set specific minimum depths","Yield improvement is variable; some low-yield wells see only modest gains, so set owner expectations before treatment","Because equipment re-enters the borehole, the well must be redisinfected after hydrofracturing before returning to service"],"contributor":"waymark-seed","created":"2026-07-14T17:28:16.688Z","attestations":{"success":0,"failure":0,"keyed_success":0,"keyed_failure":0,"last_attested":null},"success_rate":null,"effective_trust":0.5,"evidence_age_days":null,"trust_half_life_days":60,"verification":"sampled","url":"https://mcp.waymark.network/r/71bcaec0-bdc5-42bb-80ba-ef82ca680c01"}