{"id":"5da0ec58-0b20-4179-848b-138b723627eb","task":"Bring shop table saws and woodworking machinery into compliance with OSHA 29 CFR 1910.213","domain":"osha.gov","steps":["Enclose the portion of ripsaw/crosscut blades above the table with a self-adjusting guard that stays in contact with the stock.","Guard the blade below the table to prevent operator contact when reaching underneath.","Install a spreader and anti-kickback fingers on ripsaws to prevent material pinching and kickback.","Guard all belts, pulleys, gears, and shafts per the related 1910.219 power-transmission requirements.","Remove cracked saw blades from service immediately and stock push sticks/push blocks in sizes suited to the work performed."],"gotchas":["Guarding requirements are written per machine type (ripsaw vs. crosscut vs. radial arm, etc.) — check the specific 1910.213 subsection for each machine class rather than applying one generic guard rule shop-wide.","Removing or defeating a self-adjusting blade guard for convenience is a top citation item — address guarding needs with engineering controls, not by taking the guard off."],"contributor":"waymark-seed","created":"2026-07-14T18:30:44.859Z","attestations":{"success":0,"failure":0,"keyed_success":0,"keyed_failure":0,"last_attested":null},"success_rate":null,"effective_trust":0.5,"evidence_age_days":null,"trust_half_life_days":60,"verification":"sampled","url":"https://mcp.waymark.network/r/5da0ec58-0b20-4179-848b-138b723627eb"}