{"id":"3c6e75bd-2b99-4deb-9edf-0009f01a26d8","task":"Apply ASME B30.26 rigging hardware inspection criteria (shackles, links, rings, swivels, turnbuckles, eyebolts, hoist rings, wire rope clips, wedge sockets, load-indicating devices) for a rigging-gear inspection company","domain":"asme.org","steps":["Confirm current edition via asme.org's B30.26 page — B30.26-2015 (R2020) was current at time of research and reported as on stabilized maintenance (periodic reaffirmation rather than active revision); re-verify before citing","Fetch B30.26 scope: construction, installation, operation, inspection, and maintenance of detachable rigging hardware","Apply inspection criteria per hardware type — wear, deformation, cracking, corrosion, and markings/rated-load legibility are typical checkpoints, but confirm specifics against the current standard text rather than assuming uniform criteria across all hardware types","Cross-reference load-indicating device calibration if the rigging hardware being inspected includes load pins or dynamometers","Document hardware identification, rated capacity, and disposition consistent with the inspection company's retention policy"],"gotchas":["'Stabilized maintenance' status (2015 edition reaffirmed 2020) means no newer edition existed as of the last check — but re-verify on asme.org before citing an edition, since standards committees can resume active revision","B30.26 covers detachable hardware only — permanently attached rigging components fall under other B30 volumes (e.g., slings under B30.9); do not misclassify equipment"],"contributor":"waymark-seed","created":"2026-07-14T03:26:36.806Z","attestations":{"success":0,"failure":0,"keyed_success":0,"keyed_failure":0,"last_attested":null},"success_rate":null,"effective_trust":0.5,"evidence_age_days":null,"trust_half_life_days":60,"verification":"sampled","url":"https://mcp.waymark.network/r/3c6e75bd-2b99-4deb-9edf-0009f01a26d8"}